Workspace

Equipment And Physical Ports

Model the front, rear and internal connections without turning the map into a wiring spreadsheet.

Start from a template

Use a library device when its layout is close to your hardware. Edit a copy for the actual model, port names and connectors. A template is reusable; each placed device has its own identity and state.

Lay out a panel

In Create Device Template, choose Front, Rear or Backplane. Add individual ports or use the bulk port controls for a switch, router or patch panel. Arrange Ports gives you a starting grid. Drag ports to match the physical panel, then label them as they appear on the equipment.

Connector versus transport

The connector describes the physical fitting: RJ45, BNC, SFP+, HDMI or IEC C14. The transport describes what it carries: Ethernet, SDI, DVB-ASI, RF or AC power. Choose a common value from the list, or use Other to save a custom value. Matching connector names do not guarantee compatible signals.

Direction and internal feeds

Inputs receive, outputs send, and bidirectional ports can do both. Mark Generates A Signal only for a modeled source. For an output that depends on an input, choose its Internal Feeds. All selected feeds are required. This is also where you describe deliberate conversions such as SDI input to a transport output.

Report live port state

Select a check under Live State From Check. Use a measured link or signal reading from the device or its neighbor. A passive patch panel cannot report that a cable was removed by itself. Without a measurement, treat its state as configured or inferred.

Wire presentation

Each wire has its own rounded, square or straight route and its own middle, end or hidden labels. Change these in the wire editor. Hide all wires for a clean overview, then click a port to trace just the path you need.